Manual of Human Matrix Metalloproteinase-10 (MMP-10) ELISA Kit

Manual of Human Matrix Metalloproteinase-10 (MMP-10) ELISA Kit This reagent is for research use only: This kit is used for the determination of matrix metalloproteinase-10 (MMP-10) in human serum, cell supernatant and related liquid samples content. Experimental principle: This kit uses the double antibody sandwich method to determine the level of human matrix metalloproteinase 10 (MMP-10) in the specimen. Microporous plates were coated with purified human matrix metalloproteinase 10 (MMP-10) antibody to make solid-phase antibodies, and human matrix metalloproteinase 10 (MMP-10) was added to the monoclonal antibody-coated microwells in turn, followed by HRP The labeled matrix metalloproteinase 10 (MMP-10) antibody binds to form an antibody-antigen-enzyme-labeled antibody complex. After thorough washing, the substrate TMB is added for color development. TMB is converted into blue under the catalysis of HRP enzyme, and into the final yellow under the action of acid. The color depth is positively correlated with human matrix metalloproteinase 10 (MMP-10) in the sample. The absorbance (OD value) was measured with a microplate reader at a wavelength of 450 nm, and the concentration of human matrix metalloproteinase 10 (MMP-10) in the sample was calculated by a standard curve. Kit composition: kit composition 48 well configuration 96 well configuration storage instructions 1 copy 1 copy sealing film 2 pieces (48) 2 pieces (96) 1 sealed bag 1 enzyme coated plate 1 × 48 1 × 96 2 Store standard at -8 ° C: 900 μg / L 0.5ml × 1 bottle 0.5ml × 1 bottle Store standard dilution at 2-8 ° C 1.5ml × 1 bottle 1.5ml × 1 bottle at 2-8 ° C Store enzyme label reagent 3 ml × 1 bottle of 6 ml × 1 bottle of sample diluent 3 ml at 2-8 ° C × 1 bottle of 6 ml × 1 bottle of 2-8 ° C storage of developer A solution 3 ml × 1 bottle of 6 ml × 1 bottle of 2-8 ° C Storage Developer B solution 3 ml × 1 bottle 6 ml × 1 bottle at 2-8 ° C Storage stop solution 3ml × 1 bottle 6ml × 1 bottle 2-8 ° C Concentrated washing solution (20ml × 20 times) × 1 bottle (20ml × 30 times) × 1 bottle at 2-8 ° C to store the sample processing and requirements: 1. Serum: room temperature blood coagulates naturally for 10-20 minutes, centrifuged for about 20 minutes (2000-3000 rpm). Collect the supernatant carefully and centrifuge again if a precipitate appears during storage. 2. Plasma: EDTA or sodium citrate should be selected as the anticoagulant according to the requirements of the specimen, mixed for 10-20 minutes, and centrifuged for about 20 minutes (2000-3000 rpm). Collect the supernatant carefully. If a precipitate forms during storage, it should be centrifuged again. 3. Urine: collected in a sterile tube and centrifuged for about 20 minutes (2000-3000 rpm). Collect the supernatant carefully. If a precipitate forms during storage, centrifuge again. Pleural and ascites, cerebrospinal fluid reference implementation. 4. Cell culture supernatant: When detecting secreted components, collect with a sterile tube. Centrifuge for about 20 minutes (2000-3000 rpm). Collect the supernatant carefully. When detecting the components inside the cells, dilute the cell suspension with PBS (PH7.2-7.4), the cell concentration will reach about 1 million / ml. Through repeated freezing and thawing, the cells are destroyed and the intracellular components are released. Centrifuge for about 20 minutes (2000-3000 rpm). Collect the supernatant carefully. If a precipitate forms during storage, it should be centrifuged again. 5. Organize the specimen: after cutting the specimen, weigh it. Add a certain amount of PBS, PH7.4. Quickly freeze and save with liquid nitrogen for later use. After the specimen melts, it still maintains a temperature of 2-8 ° C. Add a certain amount of PBS (PH7.4) and homogenize the specimen with a manual or homogenizer. Centrifuge for about 20 minutes (2000-3000 rpm). Collect the supernatant carefully. After aliquoting, a portion is to be tested, and the rest is frozen for future use. 6. The specimen should be extracted as soon as possible after collection. The extraction should be carried out according to relevant literature. If the test cannot be performed immediately, the specimen can be stored at -20 ° C, but repeated freezing and thawing should be avoided. 7. Samples containing NaN3 cannot be detected because NaN3 inhibits the activity of horseradish peroxidase (HRP). Operating steps Dilution and sample loading of standards: set up 10 wells of the standard on the enzyme-coated plate, add 100 μl of the standard in the first and second wells, and then add the standard in the first and second wells 50μl of diluent, mix well; then take 100μl from the first well and the second well and add them to the third and fourth wells respectively, and then add 50μl of standard diluent to the third and fourth wells respectively, mix well; Then take 50μl each in the third and fourth wells and discard it, then add 50μl each to the fifth and sixth wells, and then add 50ul of the standard dilution solution to the fifth and sixth wells respectively, and mix well; After mixing, take 50μl from the fifth and sixth wells and add them to the seventh and eighth wells respectively. Then add 50μl of the standard dilution solution to the seventh and eighth wells respectively. Take 50μl from the eight wells and add them to the ninth and tenth wells. Then add 50μl of the standard dilution solution to the ninth and tenth wells. After mixing, take 50μl from the ninth and tenth wells and discard. (After dilution, the volume of each well is 50 μl, and the concentration is 600 μg / L, 400 μg / L, 200 μg / L, 100 μg / L, 50 μg / L respectively). Sample addition: set up blank wells (the blank control wells do not add samples and enzyme reagents, the rest of the steps are the same) and the sample wells to be tested. Add 40μl of sample diluent to the test sample well of the enzyme-coated plate, and then add 10μl of the sample to be tested (the final dilution of the sample is 5 times). Add the sample and add the sample to the bottom of the well of the microplate, try not to touch the wall of the well, shake gently to mix. Incubation: Seal the plate with a sealing film and incubate at 37 ° C for 30 minutes. Mixing solution: Dilute 30 times (20 times of 48T) concentrated washing solution with distilled water 30 times (20 times of 48T) and then reserve. Washing: Carefully peel off the sealing film, discard the liquid, spin dry, fill each well with the washing solution, let it stand for 30 seconds, then discard, repeat 5 times and pat dry. Enzyme addition: Add 50μl of enzyme label reagent to each well, except for blank wells. Incubation: The operation is the same as 3. Washing: The operation is the same as 5. Color development: Add 50μl of developer A to each well, then add 50μl of developer B, mix gently, and develop at 37 ℃ for 15 minutes in the dark. Li to yellow). Measurement: The absorbance (OD value) of each well was measured in sequence with the blank air conditioner at zero and 450 nm wavelength. The measurement should be carried out within 15 minutes after adding the stop solution. Note: The kit should be taken out of the refrigerated environment and equilibrated at room temperature for 15-30 minutes before use. If the enzyme label coated plate is unopened after opening, the strip should be stored in a sealed bag. Crystals may be precipitated in the concentrated washing liquid, which can be heated and dissolved in a water bath during dilution, and the results will not be affected during washing. The sampler should be used at each step of sample addition, and the accuracy should be regularly checked to avoid test errors. It is best to control the sampling time within 5 minutes. If there are many specimens, it is recommended to use a volley gun to add samples. Please make a standard curve at the same time of each measurement, it is best to make a double hole. If the content of the test substance in the specimen is too high (the OD value of the sample is greater than the OD value of the first well of the standard well), please first dilute it with a certain multiple (n times) of the sample diluent and then determine it. When calculating, please multiply the total dilution Multiple (× n × 5). The sealing film is limited to one-time use to avoid cross-contamination. Please keep the substrate away from light. Carry out the operation in strict accordance with the instructions. The test result must be determined by the reading of the microplate reader. All samples, washing liquid and various wastes should be treated as infectious agents. The components of different batches of this reagent shall not be mixed. 10. If there is any difference with the English manual, the English manual shall prevail. Calculation: Taking the concentration of the standard as the abscissa and the OD as the ordinate, draw a standard curve on the graph paper, and find the corresponding concentration from the standard curve according to the OD value of the sample; multiply by the dilution factor; The linear regression equation of the standard curve is calculated by the concentration and OD value of the sample, the OD value of the sample is substituted into the equation, the sample concentration is calculated, and then multiplied by the dilution factor, which is the actual concentration of the sample. (This picture is for reference only) Kit performance: 1. The linear regression coefficient of the sample and the expected concentration correlation coefficient R value is above 0.95. 2. Within and between batches should be less than 9% and 11% respectively. Storage conditions and expiration date: 1. Kit storage :; 2-8 ℃. 2. Validity: 6 months

Non Woven Bag Tote Bags can make a good substitute for carrying groceries and the shopping. You can keep the bag with the cashier, and then put your purchases into it instead of the usual plastic bag.
Recycling the bags you already have is another good idea. These can come into use for various purposes, like holding your garbage, instead of purchasing new ones.
While governments may be working out ways to lessen the impact of Plastic Bags on the environment; however, each of us should shoulder some of the responsibility for this problem, which ultimately harms us. Plastics are not only non-biodegradable, but are one of the major pollutants of the sea. For a clean and green environment, try to use alternatives to plastic whenever and wherever possible. Cut down your use of plastic, and do your bit to save our planet.

Our company focus on Custom Eco Friendly Non Woven Bag Tote. We allow you to make a choice from a wide range of products in bags that come in all sizes, and these can be used repeatedly and last for years if taken care of. Upload the Non Woven Grocery Bag artwork you wish to have printed on your Eco Non Woven Bags wholesale order and let us do the rest. You can choose some smart color options, sizes, and shapes of bags to suit your store. Have a look at some examples of past orders for Recycled Bags Wholesale we have made to spark some ideas of your own to help your brand goes more popular.

Non Woven Bag Tote, is more and more popular in nowadays, most of reports show PP Non Woven Bags that look like a cross between paper and cloth and are now being used widely as a replacement for plastic bags, especially widely used for shopping tote bag, reusable grocery bags. 

Non Woven Grocery Bag are white trash instead of new products, with the increase of new energy sources, the government to promote green energy, and increasingly serious environmental pollution, in order to get rid of this white pollution, make our lives better, many environmentally conscious people think of a new product - woven bags, and its advantages are obvious.

Why choose us ?

We are professional china manufacture of shopping Eco Non Woven Bags  & packaging Reusable Grocery Bags, with more than 10 years production experience.

Our plant located in Wenzhou city, zhejiang  which have industry chain advantage, such as material, printing , packing and so on.

All our Non Woven Bag Tote are supported by ALIBABA Trade assurance. No need to concern the business will not completed in time.

Our PP Non Woven Bags are complied with EU stand,total Eco-friendly to the world.

We have professional inspection worker and engineer to check the goods 100%, but also we have specialized after- sales department to solve your problem as soon as possible 

Our company is customer-centered and much attention has been paid to personnel. With elaborate management, we aim to achieve sustainable development and become a clear-conscience company. We'll provide you the best quality Shopping Tote Bag and Eco Non Woven Bags with competitive price.

PP Non Woven Bags

Non Woven Bag Tote,Non Woven Grocery Bag,Foldaway Non Woven Bags,Eco Non Woven Bags

WenZhou JinYuan Packing Manufacture Co.,Ltd , https://www.tote-shoppingbag.com